Product Description
Genasun GV-5 5A Custom Voltage MPPT Solar Charge Controller GV-5-Pb-CV
This regulator is setup in the factory to suit your batteries CV - Please note required charge voltage and send a copy of the battery spec sheet when placing order.
Overview
Small, critically efficient, and cost-effective, the GV-5 gets more from every panel.
- 5A 65W
- LVD - Low Voltage Disconnect
- 99.85% Peak Efficiency
- Electrolytic-Free, Ceramic Capacitors
- Doesn't wear out from heat
- High-Speed MPPT
- IP40
- Advanced electronic protections
- 10 Year Warranty
Mission-Critical Reliability
Genasun controllers are deployed to the most remote locations on earth. They endure years at sea, harsh Antarctic winters, freezing conditions in the upper atmosphere on solar powered airplanes, and in a few off-the-map locations. Made in the USA, each controller is put through complete electrical testing to ensure reliability. If you need mission-critical power, this is your controller.
Get the Ceramic Edge. Electrolytic-Free with 10 Year Warranty
Genasun’s Ceramic controllers set a new benchmark for reliability. Traditional controllers have components filled with fluid electrolytes that boil off over time, causing system failure. Genasun Solid Ceramic controllers have no fluid. They don’t wear out in the heat. Backed by an industry leading 10 year warranty, these controllers take reliability to a new level.
High-Speed MPPT: Always on Target
Not all Maximum Power Point Tracking controllers were created equally. Most use a sweep and sleep method that scans the entire voltage range every 30-60 seconds. That's okay for a clear day, but traditional controllers are constantly off target during changing cloud conditions – exactly when power is scarce and is needed the most. Genasun controllers adapt to changing light conditions 20 times every second. They are always on target, capturing every bit of available sunshine. Simply put, other controllers can't keep up.
Advanced Lithium Charging Algorithms
Our Lithium charging algorithms draw from nine years of experience building Lithium battery packs for harsh environments. We've worked with every chemistry, and have tailored charge profiles to help you get more capacity and cycle life from your battery pack.
Custom Voltages Available
Genasun stocks the GV-5 for lead-acid battery and for a variety of Lithium chemistries and cell configurations. A custom charge profile can be programmed at the factory to match the specs of your lead-acid or Li battery. To order a Custom Voltage controller, hit the "Customize" button in the SKU GV-5-Pb-CV or GV-5-Li-CV on the e-commerce page, and select the custom voltages from the drop-down menu. For further information drop us an email to techsupport @ sunforgellc.com.
Made in the USA
Features
Surviving the Storm with Low Power Burn
Every controller uses power. While a typical PWM controller burns 9mA, the Genasun GV-5 burns a scant 0.125mA. That slow burn is perfect for waiting out a snow-covered panel, or a few bad weeks of clouds.
Partial Shade – In-City Applications
Genasun controllers shine in partial shade. The 50% power increase from Genasun’s advanced MPPT is often enough to prevent system downtime from partial shade. From street signs and tree branches, to coffee cups and stickers placed on panels by pedestrians, Genasun MPPT keeps partially shaded solar panels generating more power than any other controller.
Complete Power Management.
The GV-5 does it all. Plug in the solar panel, connect the battery, and connect the load. The GV-5 will automatically maximize the solar power collected. The advanced battery charging algorithm will maximize the lifetime and capacity of your battery system. The load output will provide smooth, filtered power without the AC chatter found in lesser controllers. This little black box does it all, efficiently and consistently.
Steady Power Source
Life is unpredictable. PWM controllers amplify that unpredictability. A small amount of shade can drop PWM power output to 2/3's of what a Genasun MPPT controller can draw from the same panel. By constantly adapting to changing light conditions, Genasun’s advanced MPPT controllers provide a steadier source of power, keeping your system running in uncertain weather.
Radio Silence
Most MPPT solar charge controllers broadcast Radio Frequency noise from the DC/DC conversion circuit. Unfiltered inputs and outputs waste energy and interfere with nearby or attached electronics. Genasun worked to eliminated RF emissions from our line of charge controllers. During third-party testing for FCC compliance, the test engineer asked us, “Is it on?”. Mission accomplished.
No Fans. No Relays.
Fans get clogged with dust and dirt. Relays eventually stop switching. Genasun controllers use advanced electrical design that obsoletes these parts. With fewer moving parts to wear out, Genasun controllers outlast the competition.
Plug and Play, with Advanced Error Protections
We all make mistakes. People plug panels in backwards. Rodents chew through cables and cause short circuits. Stuff happens. But don't worry, we've got you covered. Advanced built-in electronic protections will instantly cut power to a short circuit. The controller will automatically test to see when the short is removed. Once it's clear, normal operation will resume.
Fault Tolerance.
Electronic reverse-battery protection.
Electronic reverse-panel protection.
Load protected from reversed battery.
Warranty & Support
The GV-5 solar charge controllers carry a 10-year warranty on materials and workmanship. Genasun’s warranty does not cover damage due to abuse or operation beyond the rated specifications.
Specifications
For Lead-Acid Batteries
| GV-5-Pb-12V | |
|---|---|
| Maximum Recommended Panel Power | 65 W |
| Rated Battery Current | 5 A |
| Nominal Battery Voltage | 12 V |
| Max Input Voltage | 27 V |
| Recom. Max Panel Voc at STC | 22 V |
| Minimum Battery Voltage for Operation | 7.2 V |
| Trickle Charge to Recover Dead (O V) Battery | Yes |
| Maximum Input Short Circuit Current* | 5 A |
| Continuous Rated Load Current | 5 A |
| Maximum Input Current** | 9 A |
| Charge Profile | Multi-Stage with Temperature Compensation |
| Absorption Voltage | 14.2 V |
| Absorption Time | 2 hours |
| Float Voltage | 13.8 V |
| Load (LVD) Disconnect/Reconnect Voltage | 11.4 V / 12.5 V |
| Battery Temperature Compensation | -28 mV/°C |
| Operating Temperature | -40°C - 85°C |
| Maximum Full Power Ambient | 50°C |
| Electrical Efficiency | 96%-99.85% typical |
| Tracking Efficiency | 99+% typical |
| MPPT Tracking Speed | 15 Hz |
| Operating Consumption | 0.150 mA (150 uA) |
| Night Consumption | 0.125 mA (125 uA) |
| Environmental Protection | IP40 (Nickel-Plated Brass & Stainless Hardware) |
| Connection | 6-position terminal block for 12-30 AWG wire |
| Weight | 2.8 oz (80g) |
| Dimensions | 4.3" x 2.2" x 0.9" (11 cm x 5.6 cm x 2.5 cm) |
| Warranty | 10 years |
For Lithium Batteries
| GV-5-Li-10.7 | GV-5-Li-12.5V | GV-5-Li-14.2V | GV-5-Li-16.7V | |
|---|---|---|---|---|
| Maximum Recommended Panel Power | 50W | 55W | 65W | 75W |
| Rated Battery (Output) Current | 5A (-SP model: 2A) | |||
| Nominal Battery Voltage | N/A | |||
| Max Input Voltage | 27 V | |||
| Recom. Max Panel Voc at STC | 22 V | |||
| Minimum Battery Voltage for Operation | 7.2 V | |||
| Trickle Charge to Recover Dead (OV) Battery | Yes | |||
| Input Voltage Range | 0 V - 27 V | |||
| Maximum Input Short Circuit Current | 5 A (-SP model:2 A)* | |||
| Continuous Rated Load Current | 5 A | |||
| Maximum Input Current** | 9 A | |||
| Charge Profile | CC-CV | |||
| Absorption Voltage | - | |||
| Absorption Time | - | |||
| Float Voltage | 10.7 V | 12.5 V | 14.2 V | 16.7 V |
| Load (LVD) Disconnect/Reconnect Voltage | 8.2 V / 9.0 V | 9.3 V / 10.5 V | 11.0 V / 12.0 V | 12.4 V / 14.0 V |
| Battery Temperature Compensation | Disabled | |||
| Operating Temperature | -40°C - 85°C | |||
| Maximum Full Power Ambient | 50°C | |||
| Electrical Efficiency | 94%-99.85% typical | |||
| Tracking Efficiency | 99+% typical | |||
| MPPT Tracking Speed | 15 Hz | |||
| Operating Consumption | 0.150 mA (150 uA) | |||
| Night Consumption | 0.125 mA (125 uA) | |||
| Environmental Protection | IP40 (Terminals Nickel Plated) | |||
| Connection | 6-position terminal block for 12-30 AWG wire | |||
| Weight | 2.8 oz (80 g) | |||
| Dimensions | 4.3" x 2.2" x 0.9" (11 cm x 5.6 cm x 2.5 cm) | |||
| Warranty | 10 years | |||
**Maximum current that the controller could draw from an unlimited source. This specification is not intended for determining PV input.
